Cookies

We use cookies to enhance your browsing experience, serve personalized ads or content. By clicking " Accept cookies ", you consent to our use of cookies. Further information on cookies can be found in our Privacy Policy.
Accept cookies
Reject All

CHOOSE YOUR LANGUAGE

How to prevent medium and high power laser device condensation?

07, 2019

by oreelaser

 Today, the Oreelaser is about the anti-condensation precautions for neutral and high-power lasers in summer.

 

The internal condensation of the laser is due to the fact that the water vapor in the air has reached saturation, but the dew condensation water is precipitated by the saturated air due to the temperature drop.

 

This will cause rust damage to the internal components of the laser, which will seriously prevent the laser from working as usual.

 

The consequences of laser condensation are so serious, what are the precursors to the internal condensation of the laser? Usually, there is a small water droplet on the wall of the cold water pipe on the laser. At this time, the condensation will not spread to the inside of the laser, and it will take some time for the internal condensation to occur.

 

In general, the laser is condensed when the cooling water temperature is lower than the ambient temperature. Please see the following table for details:

图片1_副本_副本.jpg

The figure is divided into 4 blocks of color, each of which corresponds to different dew-setting temperatures: range 1 -- dew-setting temperature in the white + green area is lower than 20℃; range 2 -- dew-setting temperature in the yellow area is between 20℃ and 25℃; and range 3 -- dew-setting temperature in the red area is higher than 25℃.

 

When the environment is in the range 1, the low dew point is a safe range. We can set the cooling water temperature as required.

 

When the environment is in the range 2, it is the dangerous range of condensation, which may happen if there is a little carelessness. Therefore, Oreelaser suggests that if the cooling water temperature is close to the dew point temperature, then the water temperature can be appropriately adjusted to avoid condensation.

 

If the ambient temperature continues to rise, then it needs to be handled in range 3: the scope of the three is bound to dewing, so Oreelaser suggests installing air conditioning or machine tool outsourcing boxes to reduce the temperature when economic conditions permit, furthermore if the cooling capacity and flow of the water cooler has enough redundancy, the water temperature can be adjusted to increase by about 2 degrees Celsius, this method has limited effect, the most recommended is to reduce the working environment temperature.


Professional Laser Cutting Machine Manufacturer - OreeLaser





PREVIOUS The difference between plasma cutting mode and laser cutting mode
Auxiliary Gas | Laser cutting machine auxiliary gas types and selection NEXT

Copyright ® 2018 OREE LASER